SUMAK SMT150-S HOT WATER CENTRIFUGAL PUMP 90°C THREE PHASE

It is produced for use in hot water up to 90°C. The water wheel is made of AISI 04 stainless steel. They are single-stage centrifugal pumps. This type of pumps, suction from a depth of 6 m and a maximum of 32 m. They are ideal pumps used in small-scale irrigations up to height and in the supply of clean water as a booster in buildings not exceeding 4 floors and 16 flats. Plumbing Materials If your pump is sucking from the same level or higher code, you must use a check valve in the suction line. Check valve must be used in the discharge line of the separator pump. Click to buy check valve. If your pump is sucking below its own level, that is, from the negative code, a damper must be used to prevent air. Click to buy a valve. You can purchase a strainer to prevent your pump from being damaged by the impurities formed in the water at the time of suction. Click here to buy a strainer. Click here to take a look at the other fasteners you will definitely need. HP : 1.5 HP kW : 1.1 kW Voltage : 380 Volt (Three-phase) Max. Flow rate m3/h: 6-10 m3/h Max. Height mSS: 31-40 mss Inlet Size: 1.1/2'' - 40 mm Output Size: 1.1/2'' - 40 mm Revolution R/D: 2900 d/d Suction Depth: 6 Meters