SUMAK SMT220/3-S HOT WATER CENTRIFUGAL PUMP 90°C THREE-PHASE

SUMAK SMT220/3-S HOT WATER CENTRIFUGAL PUMP 90°C THREE-PHASE It is produced to be used in hot water up to 90°C. The water wheel is made of GG25 cast iron. They are single-stage centrifugal pumps. This type of pumps suction from 6 m and maximum 14 m. They are ideal pumps used for flood irrigation up to height, lightly polluted water discharge and high flow needs. Plumbing Materials If your pump is sucking from the same level or higher code, you must use a check valve in the suction line. Check valve must be used in the discharge line of the separator pump. Click to buy check valve. If your pump is sucking below its own level, that is, from the negative code, a damper must be used to prevent air. Click to buy a valve. You can purchase a strainer to prevent your pump from being damaged by the impurities formed in the water at the time of suction. Click here to buy a strainer. Click here to take a look at the other fasteners you will definitely need. HP : 2.2 HP kW : 1.6 kW Voltage : 380 Volt (Three-phase) Max. Flow rate m3/h: 26-50 m3/h Max. Height mSS: 11-20 mss Inlet Size: 3" - 80 mm Output Size: 2.1/2" - 65 mm Revolution R/D: 2900 d/d Suction Depth: 6 Meters