SUMAK SMT400/4-S HOT WATER CENTRIFUGAL PUMP 90°C THREE-PHASE

It is produced for use in hot water up to 90°C. The water wheel is made of GG25 cast iron. They are single-stage centrifugal pumps. 50 Hz. and 60 Hz. produced at frequencies. Areas of Use: SMT400/4 Three-Phase Centrifugal Pump can be used for agricultural purposes up to a maximum height of 18 meters, with suction from 6 meters and drip irrigation, tanker water discharge, bilge water discharge on ships, lightly polluted accumulation water discharge and high flow water needs. Pump Material Specifications: Pump Body: GG 25 Cast Impeller: GG 25 Cast Shaft: AISI 304 INOX Liquid Discharge Temperature: 0-45 °C / (*120 °C) Protection Class: IP 54 Insulation: CI.F Mechanical Seal: Ceramic /Carbon * THERMAL PROTECTION is available in Monophase models against overloads. Plumbing Materials If your pump is sucking from the same level or higher code, you must use a check valve in the suction line. Check valve must be used in the discharge line of the separator pump. Click to buy check valve. If your pump is sucking below its own level, that is, from the negative code, a damper must be used to prevent air. Click to buy a valve. You can purchase a strainer to prevent your pump from being damaged by the impurities formed in the water at the time of suction. Click here to buy a strainer. Click here to take a look at the other fasteners you will definitely need. HP : 4 HP kW : 3 kW Voltage : 380 Volt (Three-phase) Max. Flow rate m3/h: 76-100 m3/h Max. Height mSS : 11-20 mss Inlet Size : 4" - 100 mm Outlet Size : 4" - 100 mm Revolution RPM : 2900 d/d Suction Depth : 6 Meters