MANUAL SANDBLASTING CABINET

Surface cleaning, removal of rust and surface roughening of parts that are too big to fit in the automatic machine The dimensions of the sandblasting cabinet are determined according to the product dimensions of our customers, and they are specially designed and produced. The operator enters into the sandblasting chamber and manually carries out the sandblasting process by holding the ball sprayed from the nozzle to the surface of the part. The operator is protected from sand blow by wearing a sandblasting helmet and a half coverall, and breathes fresh air as the air inside the helmet is constantly circulating. It is very important both for the health of the operator and for the operator to work efficiently with a clear view of the surface to be blasted, keeping the dense dust generated during sandblasting quickly away from the cabin and keeping it in the filter and giving the clean air to the outside of the facility. Thanks to our special air circulation design, no dust remains in the cabinet during sandblasting. Thanks to the bottom blasting channel located under the cabin interior floor, the product does not need to be turned upside down to blast the bottom surface of the products. The operator also sands the bottom surface of the product by walking through the blast channel from the bottom. On both long walls of the cabin, there are automatic platforms that move back and forth and up and down, controlled by the operator by pressing the pedal. Efficiency is maximized as 3 operators can work at the same time, with 2 operators working on the right and left platforms, and the 3rd operator in the bottom blast channel.