COTTON PAINT EXTERIOR

Acrylic Exterior Paint Product Description: Acrylic emulsion-based, water-based exterior paint. Since it has water vapor permeability, it allows moisture to escape. It is resistant to moisture and water, has high covering, alkali and chemical resistance. Usage Area: It is used on all kinds of concrete, gas concrete, briquette, brick, plaster and similar mineral surfaces. Method of Application: The surface to be applied must be cleaned of all kinds of oil, dirt, loose and swollen layers, and a surface must be created where the paint can be adhered to in glassy and glossy textures. PMR Exterior Putty should be used for repairing and stripping hairline cracks. On raw plastered, new and solid surfaces; PMR Exterior Primer should be applied as a single coat. Old painted, very chalky, absorbent, weak etc. On loose textured surfaces, the surface should be saturated with PMR Binder Primer to strengthen the floor. “Isolation primers should never be used in the priming process. “ If it is going to be applied on cement-based decorative plaster used in the thermal insulation system, PMR Binder Primer must be used as a primer. At least 24 hours after the priming process, two coats should be applied by diluting with water by 10-15% by volume and waiting for at least 6 hours between coats depending on the weather conditions. It should not be applied in rainy weather. Technical Specifications: General Information Appearance Matte appearance, colored, top coat exterior wall paint Structure Acrylic Emulsion Binder Density 1.55 gr/cm3 Thinner Water Thinning Ratio 10-20% Color PMR Exterior Color Chart and Application Information in the desired color Application Temperature 20° C, 50% RH Drying Time Min. 24 Hours (20 oC, 50% RH) Waiting Time Between Coats Min. 6 Hours (20 oC, 50% RH) Consumption 1 Lt to 9 -11 m2 (One Coat) Recommended Application Level 2 Coats (May vary depending on substrate condition) Recommended Primer PMR Exterior Primer or PMR Binder Primer Application Tools Roller, Brush Points to be Considered in Application with Spray or Airbrush: Before use, the paint should be mixed in the box until it becomes homogeneous. Surface problems may occur in applications performed in environments below +5 oC and above +35 oC. On surfaces where repair mortars and putty are used, a very thin 1 coat of transparent paint primer should be used. The transparent primer used should be used in a way that does not leave a film thickness on the surface. Paint application on transparent primer should be done after 24 hours. Application surfaces must be dry and clean. The application should be made according to the specified Application specifications. It should not be thinned more than 10-20%. Waiting times between coats must be observed. Cleaning of Application Tools: Application tools should be cleaned with water immediately after use. Safety Warnings: S2 Keep out of reach of children. S24/25 Avoid contact with eyes and skin. S26 In case of contact with eyes, rinse thoroughly with water and seek medical advice. S28 In case of contact with skin, wash immediately with plenty of water. S29 Do not discharge into sewers. S46 If swallowed, seek medical advice immediately and show the container or label. SUITABLE for TS 7847