COTTON PAINT INTERIOR

Silicone Matte Interior Wall Paint Product Definition: Acrylic emulsion based, silicone added, easy to apply, good covering, cleanable, breathable, water-based matt topcoat interior paint. Usage Area: It is used as a decorative and surface protective paint on walls, ceilings, plaster, concrete, gas concrete, exposed concrete, gypsum plaster, gypsum board, chipboard, mdf, betopan, brick, paintable wallpapers, putty surfaces and old painted surfaces. Method of Application: The surfaces to be applied must be cleared of free dust, swollen and loose textured layers. Dust, oil, soot and contamination on the surface should be thoroughly cleaned. Surface defects should be corrected with PMR Interior Paste and made ready for painting. If necessary, PMR Binder Primer or PMR Interior Primer should be used. PMR Hera Silicone Mat is diluted with 15 – 20% water and applied in 2 coats with a brush or roller, waiting at least 2-3 hours between coats. Technical Specifications: General Information Appearance Matte, colored, top coat interior wall paint Structure Acrylic Emulsion Binder, Silicone added Density ~1,60 gr/cm3 Thinner Water Thinning Ratio 15-20% Color PMR Interior Wall Chart and Application Information in Desired Color Application Temperature 20°C, 50% RH Drying Time Min. 24 Hours (20°C, 50% RH) Waiting Time Between Coats Min. 4 Hours (20°C, 50% RH) Consumption 1 Lt to 13-15 m2 (One Coat) Recommended Application Floor 2 Coats (May vary depending on substrate condition) Recommended Primer PMR Binder Primer and PMR Interior Primer Application Tools Roll, Considerations for Application with Brush or Airbrush: Before use, the paint should be mixed in the box until it becomes homogeneous. Surface problems may occur in applications performed in environments below +5 °C and above +35 °C. A very thin 1 coat of transparent paint primer must be used on surfaces where gypsum putty, satin plaster or acrylic putty is used. The transparent primer used should be used in a way that does not leave a film thickness on the surface. Paint application on transparent primer should be done after 24 hours. Application surfaces must be dry and clean. The application should be made according to the specified Application specifications. It should not be thinned more than 20%. Waiting times between coats must be observed. Cleaning of Application Tools: Application tools should be cleaned with water immediately after use. Safety Warnings: S2 Keep out of reach of children. S24/25 Avoid contact with eyes and skin. S26 In case of contact with eyes, rinse thoroughly with water and seek medical advice. S28 In case of contact with skin, wash immediately with plenty of water. S29 Do not discharge into sewers. S46 If swallowed, seek medical advice immediately and show the container or label. SUITABLE for TS 5808