COTTON DYE INDUSTRY

Synthetic Topcoat Paint Product Description: Alkyd binder-based, superior features, high coverage, semi-gloss and color tones that do not change for years, protect the surfaces on which it is applied and give it a decorative appearance. It is a lead-free, decorative and protective top coat paint that provides smooth surfaces with its ease of application and good spreading properties. Usage Area: It is used with suitable primers on interior and exterior parts of buildings, furniture, agricultural vehicles and all kinds of wooden and metal surfaces. Application Method: New metal surfaces on which PMR Synthetic Topcoat will be applied should be primed with PMR Antirust after cleaning from all kinds of dirt, rust and oil, and new wooden surfaces should be primed with PMR Synthetic Primer after the knots are burned and saturated with colorless wood preservative. In brush and roller applications, 1 L of paint is diluted with 100-150 ml, in application with a spray gun, 250-300 ml with PMR Synthetic Thinner. It is recommended to wait 1 day between coats, two coats are applied. Cleaning of brushes and tools after application can be done with PMR Synthetic Thinner. Technical Specifications: General Information Appearance Semi-glossy appearance, colored, flat, top coat paint Structure Alkyd Binder Resin Density ~1.48 gr/cm3 Thinner Synthetic Thinner Thinning Ratio 10-15% Color PMR Synthetic Group Chart Colors and Application Information in Desired Color Application Temperature 20°C, 50% RH Drying Time Max. 48 Hours (20°C, 50% RH) Waiting Time Between Coats Min. 24 Hours (20°C, 50% RH) Consumption 1 Lt to 14-16 m2 (One Coat) Recommended Application Layer 2 Coats (May vary depending on substrate condition) Recommended Primer PMR Anticorrosion and PMR Synthetic Primer Application Tools Roller, Brush or Matters to be Considered in Spray Application: Before use, the paint should be mixed in the can until it becomes homogeneous. Do not apply in environments below +5 oC and above +35 oC. (Otherwise, drying, spreading and surface problems may occur.) Application surfaces must be dry and clean. The application should be made according to the specified Application specifications. It should not be thinned more than 10-15%. Waiting times between coats must be observed. Cleaning of Application Tools: Application tools should be cleaned with PMR Synthetic Thinner immediately after use. Safety Warnings: S2 Keep out of reach of children. S16 Keep away from sources of ignition – No smoking S23 Do not breathe vapours. S29 Do not discharge into sewers. S36/37/39 Wear suitable protective clothing, gloves, eye/face protection. S46 If swallowed, seek medical advice immediately and show the container or label. Risk Warnings: R10 Flammable. R43 May cause sensitization by skin contact. R65 Harmful: May cause lung damage if swallowed. Complies with TS 39